HUMISEAL HumiSeal Thinner T64 (5-LTR-CAN)

HumiSeal® Standard Solvent Based Thinners

Overview

HumiSeal® Standard Solvent Based Thinners are specially formulated solvent blends designed to adjust the viscosity of compatible HumiSeal® protective coatings for improved application performance. These thinners maintain the original coating system balance when used with the correct HumiSeal® product range and are compliant with the RoHS Directive 2015/863/EU.

Key Technical Specs

• Product Type: Solvent-based coating thinners
• Colour: Clear
• Shelf Life: 24 months
• VOC Range: 830-950 g/L
• Application: Viscosity adjustment of HumiSeal® coatings
• Compatibility: Multiple HumiSeal® conformal coating systems

Available Thinner Grades & Compatibility

• Thinner 64: Compatible with HumiSeal® 2A64
• Thinner 73: Compatible with HumiSeal® 1B73 and 1A20
• Thinner 503: Compatible with HumiSeal® 1B12, 1B31, 1B66, 1B73
• Thinner 505: Compatible with HumiSeal® 1R32 and 1R32A-2
• Thinner 521: Compatible with HumiSeal® 1A20, 1A27, 1A33, 1B31, 1B66, 1B73, 1R32
• Thinner 535: Compatible with HumiSeal® 2A53

Typical Physical Properties

• Relative Evaporation Rate (BuAc = 1): 0.60-3.77
• Specific Gravity: 0.83-0.95
• Boiling Point: 82-137°C
• Vapour Pressure: 8.0-45.4 mmHg
• Vapour Density: 3.4-4.0 (Air = 1)
• Flash Point: -1°C to 27°C (TCC)

Application Guidelines

• Add the compatible HumiSeal® Thinner gradually to the coating system
• Mix until the required application viscosity is achieved
• Use only with compatible HumiSeal® coating products
• Follow coating manufacturer recommendations for optimum performance

Typical Applications

• Viscosity adjustment of conformal coatings
• Improving spray, dip, or brush application characteristics
• Optimising coating flow and finish
• Electronics protection and industrial coating processes

Compatibility & Safety Notes

• Highly flammable solvent-based products
• Use only in well-ventilated areas
• Wear suitable protective gloves and safety goggles
• Avoid prolonged inhalation of vapours
• Wash skin thoroughly after prolonged contact
• Flush eyes with water and seek medical advice if exposed
• Dispose of unused material according to applicable regulations
• Refer to Safety Data Sheet (SDS) before use

Regulatory Compliance

• Compliant with RoHS Directive 2015/863/EU
• Suitable for use with approved HumiSeal® coating systems

Why This Product is Chosen for Aerospace / Electronics Applications

• Maintains coating performance when adjusting viscosity
• Provides controlled evaporation characteristics for application requirements
• Supports consistent coating quality and finish
• Designed specifically for HumiSeal® protective coating systems

Practical Suggestions for Your Team

• Select thinner grade according to the specific HumiSeal® coating system
• Add thinner slowly to avoid over-reduction
• Ensure adequate ventilation during mixing and application
• Store containers sealed and away from ignition sources

Manufacturer / Product Codes

• Product Name: HumiSeal® Standard Solvent Based Thinners
• Manufacturer: HumiSeal® / Chase Corporation
• Product Family: HumiSeal® conformal coating solvents
• Available Grades: 64, 73, 503, 505, 521, 535